Model U30 High Accury Single-axis Fiber Optic Gyroscope With 0.5
°/hr Bias Drift
1. Product introduction
1.1 Working principle and functions
The strapdown inertial group of U30 fog is an inertial sensor
developed for tactical military systems. U30 by three solid-state
fiber optic gyroscope, quartz flexible accelerometer, data
packaging board, ontology structure and related software and so on,
measure the angular velocity and linear acceleration of the vehicle
movement, and temperature, install the misalignment Angle,
nonlinear, zero error compensation, as the carrier's attitude and
navigation control to provide information, measurement results
through RS422 serial bus output.
1.2 Overall dimensions
Overall dimensions:Φ(90±0.1)mm×(90±0.1)mm×(105±0.5)mm,,
The pitch of the installation:(75±0.05)mm×(75±0.05)mm,Install screw
M6.
1.3 Weight
1200g±60g
1.4 Performance parameters
| The parameter name | Required value | Note |
Range of measured angular rate
(º/s)
| ±500 | |
Add meter measurement range
(g)
| ±30 | |
Bias Drift Repeatability at
fixed temperature
(10s,1σ,º/h)
| ≤0.5 | Normal |
Bias Drift at fixed temperature
(10s,1σ,º/h)
| ≤0.5 | Normal |
Bias Drift at full temperature
range from -40° C till 60° C
(10s,1σ,º/h)
| ≤1 | Variable |
Add table zero bias repeatability
(10s,1σ,mg)
| ≤0.5 | Normal |
Bias Voltage Drift at Fixed Temperature with Meter (10s,1σ,mg) | ≤0.5 | Normal |
Scale Factor Non-Linearity at
full temperature range from
-40°C till 60° C
(ppm)
| ≤300 | |
Scale Factor Repeatability at
full temperature range from -40°C till 60° C
(ppm)
| ≤300 | |
Add scale factor nonlinearity and asymmetry
(ppm)
| ≤500 | |
Add table scale factor repeatability
(ppm)
| ≤500 | |
Vibration gyro (º/h) | Before and in the vibration | 1 | |
| Vibration in and after | |
| After and before vibration | |
Add table vibration (mg) | Before and in the vibration | 1 | |
| Vibration in and after | |
| After and before vibration | |
1.5 Mechanical and electrical interfaces
1.5.1 Mechanical interface
The mounting surface of the product constitutes the fixed surface
for external installation, and the mounting screw is M6.
1.5.2 External power supply and power consumption requirements
| Voltage | Voltage range | Ripple(RMS) | Current |
| ＋28V | ±5% | ≤100mV | ≤3.00A(Swith on the transient) |
| ≤1.00A(The steady state) |
1.5.3 Electrical connection interface
The model of gyro external connector is J30J-21ZKP3
| J30J-21ZKP3 | Define | Note |
| 1,2 | ＋28V | Power supply |
| 3,4 | GND |
| 5,10 | RX＋ | RS-422 |
| 6,11 | RX－ |
| 8,13 | TX＋ |
| 7,12 | TX－ |
| 9,14 | GND |
